What Counts as Floor Area in NYC? Attics, Basements, and Cellars
Short answer: In NYC zoning, "floor area" is the space that counts toward how much you're allowed to build (your FAR). A cellar — a level that sits more than halfway below the curb — does not count. A basement — a level that's at least half above the curb — does count. Attics usually count once they're usable space.
What "floor area" actually means
When people talk about how big a building can be, they're really talking about floor area. The city's official definition is the sum of the gross area of every floor of a building, measured to the outside walls — but with several important things left out. Your zoning district sets a Floor Area Ratio (FAR), and your floor area can't exceed the lot area multiplied by that FAR. So the question of what "counts" as floor area is really the question of how much building you're allowed.
Cellar vs. basement: the curb line decides
This is the distinction that trips up almost everyone, because in everyday speech we use "basement" for anything underground. Zoning is stricter, and it comes down to where the level sits relative to the curb:
- Cellar — a level with at least half of its floor-to-ceiling height below the curb level. A cellar is not counted as floor area.
- Basement — a level with at least half of its height above the curb level. A basement is counted as floor area.
So two identical-looking lower levels can be treated completely differently. Dig the space deeper into the ground and it becomes a cellar that doesn't eat into your buildable area; leave more of it above the curb and it's a basement that does.
What about attics?
Attic space generally counts as floor area once it's usable, habitable space — finishing an attic into a bedroom or office typically adds to your floor area. That said, some lower-density residential districts have a separate "attic allowance" that permits a limited amount of extra space under a pitched roof beyond the normal FAR. The exact rules and any allowance depend on your specific district, so this is one to confirm for your address rather than assume.
Other things that don't count as floor area
Beyond cellar space, the city's definition also leaves out several categories:
- Mechanical space (boilers, equipment rooms, and similar).
- Floor space in open balconies.
- Elevator and stair bulkheads.
- In most districts, accessory parking located less than 23 feet above the curb.
These exclusions are why the "square footage" on a listing and the "floor area" in a zoning analysis are often different numbers.
Why this matters for your project
If you're deciding whether to finish a lower level or add space, knowing what counts as floor area tells you whether you're using up your buildable area or getting it for "free." A cellar rec room, a mechanical room, or covered parking near grade generally won't reduce what you can build above — but a basement apartment or a finished attic usually will.
How to find your own number
Your allowable floor area is your lot area times your district's FAR. Look up your zoning district for your address, find the FAR for your use, and multiply by your lot's square footage. Then subtract what already exists, remembering that cellars and the other excluded categories don't count against you.
Try Zohgo
Not sure whether your lower level is a cellar or a basement, or how much floor area you have left to build? Try Zohgo free at zohgo.ai — enter your address, describe what you want to do, and it walks you through it in plain English.
This article is general information about NYC zoning, not legal or professional advice. Zoning is fact-specific and rules change; always verify the details for your property with a licensed professional and the current Zoning Resolution.
Comments
Post a Comment