What Is FAR? NYC Floor Area Ratio in Plain English

Short answer: FAR, or Floor Area Ratio, is how NYC zoning limits the size of a building. It's the ratio of a building's zoning floor area to the area of its lot. The formula is simple: maximum floor area = lot area × FAR. So a 2,000-square-foot lot with an FAR of 2.0 can hold about 4,000 square feet of building. A higher FAR means a bigger building on the same land.

The one formula you need

Floor Area Ratio compares how much building you have to how much land you have:

FAR = zoning floor area ÷ lot area

Turn it around and it tells you your maximum building size:

Maximum floor area = lot area × maximum FAR

Say your lot is 2,000 square feet and your district allows an FAR of 2.0. Multiply 2,000 × 2.0 and you get 4,000 square feet — the largest building the zoning permits on that lot. If the allowed FAR were 1.0, you'd be capped at 2,000 square feet; at 3.0, you'd get 6,000. Same lot, very different buildings, all driven by that one number.

Where the FAR number comes from

You don't pick your FAR — your zoning district sets it. Each district in the Zoning Resolution has a maximum FAR (and some have more than one, depending on the use or on whether affordable housing is included). To find yours, first look up your zoning district on the city's free ZoLa map, then find that district's maximum FAR in the Zoning Resolution. Because the number is district-specific, there's no single "NYC FAR" — it's whatever your lot's district allows.

Not every square foot counts

Here's where people trip up: "zoning floor area" isn't the same as every square foot you build. NYC zoning excludes certain spaces from the FAR calculation. A true cellar — a level that's more than half below the surrounding ground — generally doesn't count as zoning floor area, while a basement that's more than half above ground usually does. Some mechanical space and certain other areas can also be excluded. The details are technical and depend on how the space is built, so the safe move is to treat the raw square footage as a starting point and confirm what actually counts for your project.

Why FAR matters before you design anything

FAR is usually the first hard ceiling you hit. You can have a big lot, but if the FAR is low, the building stays small. It's also why "unused FAR" — the gap between what you've built and what you're allowed — is valuable: it can mean room to add on, extend, or, in some cases, sell air rights to a neighbor. Knowing your FAR up front tells you whether a project is even worth pursuing before you spend money on drawings.

FAR is one piece — height and yards shape the rest

FAR tells you how much you can build, but not what shape. Two lots with the same FAR can produce very different buildings once height limits, setbacks, and yard requirements come into play. So FAR is the starting point for "how big," and the other rules decide how that floor area gets arranged on the lot.

Related: What can you build on your NYC lot?

Find your FAR without the headache

Working out your zoning floor area by hand means finding your district, reading its FAR, and then sorting out which spaces count and which don't — and confirming you're using the current, post–City of Yes rules (adopted December 5, 2024). Zohgo does that reading for you: enter your address and it tells you your district's FAR and what it means for your buildable size, in plain English.

Try Zohgo free at zohgo.ai — free to start.


This article is general information about NYC zoning, not legal, architectural, or engineering advice. Floor area rules and exclusions are technical and change over time. Always confirm your specific property's numbers with the NYC Department of City Planning, the Department of Buildings, or a licensed professional before making decisions.

Comments

Popular posts from this blog

How to Find Your Zoning District for Any NYC Address (Free)

What Can You Build on Your NYC Lot? A Plain-English Guide

How Many Units Can You Add to Your NYC Home Under City of Yes?